Page 1 of 2
Letun's Osprey II project
Posted: 29 May 2020, 18:15
by Letun
Letun's Osprey II project
The unfinished design of the Osprey II aircraft came into my hands. This device was built in the USA a long time ago. Then he came to Russia, where he was completely disassembled and in it a large number of elements were made of composite materials. And some parts were designed and made anew.
Can someone recognize their project from the photo?
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:16
by Letun
Airplane completely disassembled
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:17
by Letun
The compartment where the chassis was retracted was completely redone, it was sealed and protected from water.
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:18
by Letun
The entire tail of the fuselage is converted into a sandwich construction with the manufacture of flanges to which the upper deck will be glued. The trailing edge of the wing was removed, the same fate awaits almost the entire center section structure.
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:19
by Letun
All-New Composite Tail
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:35
by Letun
Control wiring
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:35
by Letun
Flanges prepared for the upper deck sticker
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:36
by Letun
The deck is glued and is preparing for pasting with fiberglass on top
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:36
by Letun
The next approach is to change the center section
Re: Letun's Osprey II project
Posted: 29 May 2020, 18:37
by Letun
The tail is hoisted and the fuselage is nearing completion.